That would explain why I crashed then. Lol. It couldn’t have been because I was piggy backing a parrot drone with claw attachment flying my fishing line out past the third sandbar.
Try going to phone settings then Bluetooth and tell your phone to forget device G3. Close breeze app out completely. Restart app go to task then controller mode and experience now. At this point the app should link automatically to controller on its own.
I know the Breeze uses topology data in order to find it's landing zone, and to keep from hitting the ground while in flight. Is this data saved to file, or just used in real-time without being saved? It would be xyz coordinate numbers seperated by commas. I have not tried viewing any of the...
This will solve your problem:
First, make sure your controller is updated with latest firmware.
Then, on your phone, go to Bluetooth devices and forget the device for controller (Gamesir).
Turn off Bluetooth on phone, and turn off controller. Also make sure you are completely closed out of...
You need to set it to same channel, and same security as breeze. If you have an android phone, just download frequency channel scanner app, and run a scan when breeze is turned on. It will give you the SSID, the frequency, and the channel #.
If you have access to a large area, you can set up a Mesh network with Ubiquiti Unifi MESH dual band AP units. You will need to download the Unifi controller to laptop to set the mesh network up, but once it's set up the laptop is not needed. The Mesh AP units will allow data flow between 4...