Recent content by Peta

Thank you! I've already measured the actual voltages on the pins, now I have to find a motor what I can operate with this voltage levels. Dont you have a relevant advice for this?

Where did you connect the servo on the H920's FCU? And what kind of servo did you use? I want to do the same thing, but II want to use the gimbal connector. I measured the pin-s voltages, and í can modify two of them by the controller (ST24). The pitch and the roll pins' voltage can be adjusted...

I think you should get an ST16 controller. I have an H920 with ST24 and an H920 Plus with an ST16, and they are not interchangeable. If I try to contrrol the H920 Plus with the ST24 I meet exactly the same problem as yours. H920 with ST16 is even worse. And I don't think that Yuneec would do...

Dear experts! Can someone show me some drawing or figure about the pins in the system connector at the bottom of the H920? I would like to build some electronic equipment under the UAV, and I need to know whether I can get electric supply for that. Thank you for your answers! :)

Can you tell me, what kind of gimbal is this? What is the power source of this? I would like to do a similar upgrade on my H920. Thank you.

What is your problem with the main board?

Dear all, can you tell me which software did you use to visualize those data from the flight log *.csv files above in this topic? And how can I figure out which column is what? Thank you, this case and the analysis was interesting.