Recent content by PetroAg13

Hi, I just saw this post and the response from the guy that might have ghosted you. Did this sale go through?

Update: I ordered a replacement WiFi card from Yuneec Skins. I removed the old card and replace with the new. Immediately the same error came up and I am again stuck in the same "Camera Type is not match" loop. I am open to suggestions and would appreciate any help in the matter.

Ok thank you for the confirmation. In the meantime, I would still like to fly the drone even without video capabilities. I can't do that while stuck in the loop, so if someone could help me do a reset on the ST16, that would be much appreciaetd!

I just took off the back cover of the controller to see if any wires had come loose from the WiFi board, but it was all intact. I suppose that it is the WiFi board that needs to be replaced. That’s good to know that the loop will be resolved once the board is replaced. Could you verify that this...

Can you go through the process that SilentR9 went though to reset the ST16? I am having the same problem. It's frustrating since this is one of the only forums that I have found that speak about this issue, and then the solution was done on Skype.