Recent content by Powl72

Hi Steve, which camera? That one I had was the CGO3+.

Yeap! Same phone number that it was on his original email. I have left him a few voicemails with no return calls. Oh well, at this point I just have to cut my losses, and stop trying. A call back or something would have been nice. My youngest son had his gradutation party at a state park...

Hello Yuneec Family, I am giving an update of my gimbal. After a couple of attempts to fix the erratic behavior, I decided to send the camera with the preapid USPS label that John Mitchell from Yuneec Skins had provided on April 15, paid the $25 repair estimate service, but I haven't heard...

I have dissected this drone a few times already, I feel like I should change career and become a brain surgeon 😂. Sorry, but either tomorrow or next week I should try other new procedures. Thank you Vaklin for your help. Much appreciated

Trying, but losing faith. 😂

Oh okay, I think I read that somewhere. I could look into that, as well. I wanted to do that last week, but wanted to check here in case somebody gave me a different solution. Thanks again.

True, but just going through “ What if “ scenarios. Trying not to discount any possibilities. I have attached a picture of the ST16 firmware.

Oh yeah! I have computer skills. Not only I have a degree in information systems, I also build my own computers.

I turned drone on while it had the protective plastic cap on the gimbal. Just in case, I did turned the ST16 controller on first, then the drone like I usually do, but I didn’t realized that I forgot to remove that plastic protective cap off from the gimbal.

True! But also that I haven’t used flown that drone close to a year. I did, however, would turn it on and off, here and there, test the camera, and update anything, but Yuneec completely took down their legacy products down like the H480. I made sure everything was working properly. just in...

Hhhmmm, I will try that approach, and if it is the magnet? What happened was that I turned it on while it had the gimbal protective cap on. I forgot to remove it. I know I know

Thanks Valkin, I am going to try that. I will post my findings.

Hello my new Yuneec family. First of all, I just want to say thank you so much for having a lot of these solutions available on this site. I have done a lot of research to see if I can find a solution for my Yuneec 480 CGo3+ Gimbal acting erratic and coming up with these 2 long beeps and a short...