Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by Rgd

  1. R

    Flying with waypoints without cg03 gimbal/camera

    Hi HE, What I did was monitoring the com between the gimbal and the typh H. The baud rate is 115200. The 15 bytes have 12 bytes who are always the same. The third byte is a message counter and goes sequential from 0 to 255. The problem are the last two bytes. This is a sumcheck. The...
  2. R

    Flying with waypoints without cg03 gimbal/camera

    For someone, who might be interested. I managed to fly with waypoints without using the gimbal. I made a small pcb with a simple micro controller. The boards sends out each second a simple serial string of 15 bytes on the tx line. It is rather simple once you know how. I found the string by...
  3. R

    CGO 3 Camera

    Is this with the gimbal? In that case I am interested for 40 USD.
  4. R

    Flying with waypoints without cg03 gimbal/camera

    Thanks for your message. It is is not what I hoped for, but it saves me a lot of work and a dissapointment later.
  5. R

    Flying with waypoints without cg03 gimbal/camera

    I monitored allready the communication. I am bussy to make a small pcb with a microcontroller, that will reply the communication as if it was the gimbal. However I hoped there was an easier workarround. Regards Rene
  6. R

    Flying with waypoints without cg03 gimbal/camera

    Hi Russel. Thanks for your reply. I had tried that allready. At the moment I remove the gimbal data from the file, the ST16 does not see the waypoints anymore. Regards Rene
  7. R

    Flying with waypoints without cg03 gimbal/camera

    Hi, I can fly with my Typhoon H a predefined waypoints circuit as long as the gimbal and camera are mounted on the drone. I would like to fly with a special camera without the gimbal. This does not seem to work. Is there a workaround? Thanks for your help. Regards Rene