Recent content by Robhawg

I had a H920 with the ST24 and CGO4 camera. The camera would not bind properly, It would send video though it was choppy however the ST24 would not control the gimble. I was told there is no fix for this issue from Yuneec Skins. However, the H920+ works fine with the CGO4 camera and ST16.

Thank you sir

WTFDproject Thank you, I have thought about pulling the top off and looking at the connectors and board however I am not sure how the fuselage detaches from the lower structure. I have removed the screws and can lift it off a .5 inch and looks like the ECS board is part of the upper section. Is...

You are correct.

Thanks, I believe this is the right track however I have ST24 and an ST16, and both have the same issue. They both seem to connect WiFi however no gimble? I do not believe it is the camera as it works normally on the pro-action. That leaves the FCU. Or am I missing something?

I have indeed tried that and one step further, I used an ST16 setup in team mode same condition.

Thank you for your response, The Drone will fly everything seems to work except the gimble. The motors will power up and all the LED indications are correct. No on-screen faults and show ready. Where is the serial pin located? I have checked the camera wiring and all seem to be connected with...

Does anyone have a channel map for an H920 and a CGO4 for an ST24? I have noticed the channels seem to be wrong or not set correctly. Perhaps this is my issue?

Thanks again DoomMeister, This one has me scratching my head,,, The camera and gimble have been bound and the correct camera selected with no change still no gimble control. May add the camera and gimble operate normal on the ProAction platform so Not sure which direction I need to go? I also...

Thank you for the guidance, I have checked the hardware monitor all axis perform on screen. When the drone is powered up the gimble will bring the camera level and rotate right 90 deg and back to the left 90 deg then back to forward "Center", at that point the camera lens will zoom out and...

I have an H920 with an ST24 and a CGO4. Binding seems to connect the camera and I have the video feed. I do not have any control of the gimble pitch or yaw. Has anyone had this issue and if so what should I be looking for? I have looked at the gimble connector and all seems to be correct. This...