Recent content by Roblong

ok steve, I created a new model and recalabrated compass and accelerometer. it still bobbles left and right and up and down. anything else to try?

I calibrated the accelerometer also with no change

Before the update q500 would Hoover with no movement but after it varies left to right and up and down by a foot or two. I did the compass calibration. Anything else I need to try?

Steve, I can't thank you enough! I created another drone and it bound and looks to be fine. I will fly it in a while but I've got a good to go on the transmitter and the lights. Hope for the best! Thanks again

Ok I updated the transmitter and still not binding. I go through the process and see the model number on the screen, tap it and hit ok but it goes away after that. The camera is recognized and stays on the screen. I can adjust the camera up and down but no activation of the blades. It gives off...

what I meant to say was that I didn't update the transmitter just the drone. I'm working now on that. I followed the directions on binding but it would not bind.

yes but I think my problem is I only did the drone. Im working now on the st10plus

I did an update on my q500 4k today and now no power to the blades. it has lights and sound just no spinning. any help and I'm new to yuneec. also I just did the update to the drone.