Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by rossn444kc

  1. R

    Cgo2 problem after crash

    Hello, Before I send this back to Yuneec for repair maybe someone could tell me what went wrong....besides the crash. I bent the gimbal. After straightening the gimbal and starting up the the quad when I push the left stick to the left the camera turns left and when I turn the stick to the...
  2. R

    Strange lights

    I had the same problem however I was getting red flashing with white in angle mode. I never got a purple light. The quad was receiving 16 to 17 sats and the radio 10 to 11. After speaking to Yuneec, even though they said to fly it any way, I returned mine to the place I purchased it from. But...
  3. R

    LED sequence and colors

    Sorry ....New Jersey
  4. R

    LED sequence and colors

    I think I finally figured it out. When the switch is in either smart mode or angle mode the quad is constantly switching on and off of follow me and watch me. This happens about 30 seconds after initialization and I never touched the icon for it. There is a beep when it switches. I finally spoke...
  5. R

    LED sequence and colors

    Is it possible that I'm in a no Fly zone. I did a reset on the transmitter. Now the blinking is a steady green on off in smart mode and a steady red on off in the angle mode. But the motors still start? Very confused.
  6. R

    LED sequence and colors

    Thank you for your response. Before starting I downloaded the latest firmware for the quad. Also I was getting 14 sats on the q500 and 11 on the radio. Also angle mode the light was red not purple. I was outside doing this.. Tomorrow I plan on calling CS. I'm in north New Jersey and...
  7. R

    LED sequence and colors

    Hello everyone. I just got the q500+. Before flying I wanted to understand the lighting sequences of the different modes. I get the usual start up sequence. Then in safe mode I get green. However in angle mode I get red not purple. I did all the firmware updates. Then I both safe mode and in...