Recent content by SAJ

Update: RESOLVED! The problem was that two of the wires leading to the pitch motor where swapped. Reversing the wires resolved the limited arc and enabled full articulation of that motor. (The wires were swapped because they were severed in an accident and reconnected incorrectly.) @Vaklin...

Update: RESOLVED! Confirmed: This is a JST SH 3-Pin 1.00 mm pitch. (I found some. Used one successfully, have 19 spares to share!)

I previously tested the gimbal function using the tilt test. Yaw and roll tracked smoothly. Pitched tracked too, but was limited to the same short arc as with the controller. New problem - when pulling the wire out of the JST, one wire broke off Ugh! So now I am looking for a spare JST and...

Thank you @Vaklin and @WTFDproject for your responses. I think the magnet looks okay (photos attached). I will check the wires next - thanks for the images. I am certain of the placement of one of the wires because when it was severed, it was still connected by one strand, so that was...

Thank you for your reply. I am checking into authorized repair, but want to complete these home checks. Here is what I have: Motor damage: unlikely - the motor has no catches, and can be smoothly rotated by hand Bent arms: unlikely - no unusual spring or hold positions; visually looks...

During the most recent flight of my Yuneec Typhoon H with CGO3+, I flew a tad too low over a roof and clipped the bottom of the camera on the top of the roof ridge. No crash, but the event force rotated the camera in the gimbal such that it was jammed 90 degrees on the roll axis, and broke the...