Recent content by slw74

I have not tried the H Plus on the ST16, but it probably will work as the H520 works fine. That is after upgrading the ST16 firmware to the ST16s firmware.

That's very much as I did it. The only difference was that I downloaded the H520 DataPilot and loaded it from the microSD card in the controller (rather than using the update app) so I could control which version of the H520 DataPilot was loaded.

Yes, you can use an ST16 with an H520. The ST16 firmware needs to be updated with firmware for the ST16S, followed by loading the H520 DataPilot. (this ofcourse doesn't work for the H520E)

I don't advocate for any seller, but these are available on ebay. ebay Yuneec LED accessory

I just put one of my E90 cameras on a Typhoon H Plus. No change in drone or camera firmware; or change with the controller. I bound the camera to the WiFi on the controller as E90 and completed the binding to the Typhoone H Plus. I did need to reset the drone for it to control the camera, but...

Well, I finally got aroung to changing out the SR24 in the ST16S controller that wasn't working properly; primarily the camera controls. I took one out of an old ST16 donor. Everything went fine and the controller is back to 100%. Thanks to @WTFD for the advice. Attached is the photo of the SR24...

So sorry to hear that. He was a great guy who did alot to support the Yuneec community. He will be sorely missed. RIP John...

Hopefully this photo will help with the labels on the connectors. The "LT" labels are for the navigation lights on the respective arms. The landing gear connectors are on the underside of the board. Let me know if you have other questions. Stephen

Thanks for the thoughts on trouble-shooting. When I changed ST16S contollers, everything worked perfectly, so its isolated to the controller. @WTFD suggested just changing out the SR24, so I'll give that a try at this point.

It's the native ST16S. Any suggestions as to diagnostics on the SR24, or should I just change it out? I have several ST16S and ST16.

Folks, I had an interesting problem today with one of my ST-16S controllers. I was going to do a survey with one of my H520s and as I was doing my pre-flight check, all things seemed to work fine, but there was no movement of the camera gimbal. The camera intilized as always with a level...

I'm still running these files without any problem. With the prior history of "glitches" I stay with what works!

It would be helpful if you could send us the CCC file that you were using.

Vaklin, Yes to your question. The ST16 software interprets the waypoints (in a text file as listed in the CCC editor as noted), and interpolates a curved path between waypoints for a smooth motion. All of the flight commands are sent to the Typhoon H as "imitated stick commands." Those commands...

BTW, 1.6.18 works for both the E90 and the C23!