Recent content by SmittyInTheSky

I moved the module to the other H that had a more stable gyro in the GUI but it still did not activate IPS. Dang.

I'll move the RS module to the other H and report back. Many thanks for all the sleuthing.

I've connected both of my units to the gui and i think the one with the RS may have a bad gyro sensor? I see non-0 values for gyro deg/sec while idle.

One thing I find is that my altitude estimate on the ST16 is wildly inaccurate over time (+/- 10 ft while stationary on the ground) but it looks OK in the GUI. Compass and accelerometer calibrations complete without issue.

Hey, I really appreciate how far you're digging into this. Many thanks.

Can you post firmware and hardware versions please?

So I'm pretty sure I have the right model of everything. My antennas have the little plastic tubes attached and the ST16 has the three antennas. I'm pretty sure I have the "professional" series since it also came with the CGO3+ and not the 1" sensor camera that the "plus" comes with. It also...

Yes, I have both components. I can not separate them. They detach as a single module.

I believe it is required that you have the RS module installed. There's no other way for the system to determine 3D object position as ultrasonic sonar is very imprecise.

Awesome, thanks! I can get the GPS to go ready but only for a few sec and the motors still won't start. Beep chirp and whatnot. I appreciate the assist!

I've tried it every which way, enabled or disabled, no success.

Yep, I've checked. Running latest firmware everywhere. Thanks for the assist.

I've verified its showing green check mark in pc GUI and I can see infrared laser with phone.

I think my issue may be that my room is too small? It's about 16'×16', an empty garage. I was hoping this would work based on the follow-me mountain bike demo they have in their RS demo videos. Shows it can navigate a trail with fake trees on a dimly lit indoor stage with dynamic object...

I get to the point of the H chirping back after the joystick+switch4 toggle process but never get gps ready.