Recent content by Stephen1988

I have either a cgo3 or cg03+ arriving next week. I’ll keep u updated if it’s the one for ur typhoon h. I’m in Ireland so post from Northern Ireland via Royal Mail i can do, that way u avoid import charges or vat.

Only close range 🤣, doesn’t be long loosing it. Bet u could upgrade the antenna for better feed long distance, it’s the mushroom so more like the mushroom on the st16s vs the patch flat antenna which would probably give better signal in direct line with the ground station . I’m curious now what...

Cheers guys . Eventually found the fault . It’s annoying when u get a fault but when u discover the exact fault it’s a real joy 😁. Picture attached, u might see the issue

Any ideas why the 5.8g signal is not at the full strength. St16s is fitted with the 4halks range extender so should be better, could it be camera WiFi module, software or hardware issues? Pictures lags is the issue. Where to start the diagnostics for this 1. Drone itself flys great , maybe the...

Much appreciated for the input , my storage charger takes them the 50 percent, that’s the dy3 or dy5 yuneec dule charger. Stopping at 50 still gives plenty of flying and if u charge 5 or 6 batteries b4 flying it’s more than adequate for a bit of fun. Also saves reattaching them to the charger...

A discussion that has been had many times before but now after several years has anyone experienced damage due to this. The low battery warning or different charger type is of no concern as I always land with 50 percent battery remaining. I use either h480 batteries on h plus h520 or vice versa...

I didn’t know this. U learn something new every day. The controller was 1 I sold and I told buyer it was faulty, turns out he had the faulty WiFi module so he wanted it anyway. After all the testing it was still dead, removed the main board but nothing looked out of place , I think it may have...

Thank you so much for the time to look at all this. I will try a calibration to see what the results are. I should have mentioned I did in fact put the software into this myself as when I received it it was factory reset. I might need to try updating the software also. One thing i notice is the...

so a bit of an update, I tried disconnecting the stick on the other side to see would it give me the same symptoms with the both bars going to the bottom position and not returning to middle which u would think would be the default position. Bit of a mixed result, one remained in the middle, I...

Have a yuneec st16s for h plus. Right joystick seems to be dead, j3 and j4 are always in the down position. Ended up with a small crash because of this . Opened it up, wire is connected so tried disconnect and reconnected and still dead, tried a joystick out of a h480 in it to see would that...

Easily damaged cable while repairing this camera, I have some experience with this 😂😂

Some pictures of e90x wire

I had the same, was going to suggest this but I see u figured it out, when u run the calibration u have to put the slider in the middle position , if left in top position the drone thinks the top is now the middle and never goes past it, hence 45 degrees

if ur in Europe I have some new ones