Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by Thatguy842

  1. T

    Q500 Assistance Request

    DoomMeister, you rock guy! Thank you!
  2. T

    Extremely pleased I've found this site as well as it's members

    Extremely pleased I've found this site as well as it's members
  3. T

    You guys are awesome!

    I just wanted to extend a hearty thank you to all of the members that replied to my thread. Because of your replies and the wtfd project I was able to fix my uav on my own. I can't thank you enough. To the members that put the wtfd project together, I have to say that y'all must be geniuses. Any...
  4. T

    Issue with typhoon g

    No my feelings are kinda hurt at the moment.....lol. I'm going to I just looked through the wtfd project and that's some really good info.
  5. T

    Issue with typhoon g

    Yea I tried all that. Thanks guys I did however find the problem if anyone runs into this in the future. Apparently I didn't do a very clean job soldering and my blue and black leads were connected. I corrected this issue did an esc assignment updated the firmware and did a test on the GUI...
  6. T

    Issue with typhoon g

    I have an older typhoon g. It was a refurbished unit when I purchased it off of eBay. I received a "entering 5 rotor mode" on the controller. Through research I found that it was a bad esc. The unit has sat now for over a year. I have replaced the esc for motor #2 which if I'm not mistaken would...