Recent content by tommywoodcock

are you currently in the states my cell is 4094998505 i would like to get the bird from you and if you have the camera i would like it also

how much for the whole bird

i have a typhoon h and using a older gco3 camera its not the plus adn i can not get it to take the most recent update can the camera be updated without the drone if so how can i go about doing so

After a crash I went cheap and bought a cgo3 camera with a steady grip on Ebay. It has a old verson of firmware and i have the green blue and purple blocks and lines. yuneec has a update for this issue but i am unable to upgrade it can anyone help. can you upgrade the camera with out the

i have replace the contact and tested the board the board is dead i have no lights on the board and have voltage going to the board

I have found a board online can i change the board and the camera wok or is this a issue i will have to send it to yuneec

well that is a turd

Yep i checked the pins on the back and they were good with power in doing so i must has blown the fuse on the main board i have order a k fuse and now ordering a gimbal control board. What a day.

i have voltage at the red wire connected to the board and i have no lights on the board

ok ill give it a try here shortly i did know know the board had lights but that is why you are the expert

everything has checked out ok i have voltage that the plug

Hello I am having a few problems after a crash. My camera was severed at the mounts and the slip ring was damaged. I ordered a new slip ring and installed it. While i was in the gimbel i check all the connections. I have not opened the camera. I have tested the fuse and it is good. I am getting...

Hello I am having a few problems after a crash. My camera was severed at the mounts and the slip ring was damaged. I ordered a new slip ring and installed it. While i was in the gimbel. I check all the connections. I have not opened the camera. I have tested the fuse and it is good. I am getting...