Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by Windcalmer

  1. Windcalmer

    Looking for a CGO3

    I have one. It is not a +, it is a regular old one. PM me.
  2. Windcalmer

    Spare blades for H

    Just a word of advice, do not under any circumstances use aftermarket props. Only use the real yuneec props. Take a look at my thread about my crash. It was caused by aftermarket props.
  3. Windcalmer

    CGO3+ needed

    Update. Also, I have a CGO3 (non+ version) for sale. $250 and I will ship for free. I bought it on EBAY and as it turns out, It will not work with my H drone.
  4. Windcalmer

    Typhoon H rebuild

    As always WTFD, thank you for your reply and your knowledge. Also your time spent passing it on to us new guys and girls.
  5. Windcalmer

    Typhoon H rebuild

    O.K. So returning the camera adn getting the correct camera is my best option for getting it back into 100% working order. THis might explain why I got such a good deal on it. LOL
  6. Windcalmer

    Typhoon H rebuild

    I haev tried to load to the update from yuneec onto the SD card and then through the update area on the ST16 I tried to update. It just ended up saying it had timed out. BTW, the tilt worked, the pan did not. Sorry for the confusion.
  7. Windcalmer

    Typhoon H rebuild

    So the CGO3 will not work with the H? The ST16 has a picture from it, but it will not accept inputs from the st16 such as move left/right or tilt up /down.
  8. Windcalmer

    Typhoon H rebuild

    I got in my new camera, and other than that fact that it is a normal CGO3 adn not the + version everything has connetced fine. It will not turn side to side, or tilt though. The ST16 will not update the firmware for the camera though. What are the steps for updating the camera firmware for a...
  9. Windcalmer

    Typhoon H rebuild

    No all the motors you sent worked like a charm. Update, I ended up ordering the wrong props. I ordered two sets of H Plus props that would end up being too large for my old H. So I should have the new props in tomorrow as well as my replacment camera. Fingers crossed for a working Typhoon H.
  10. Windcalmer

    Clips into H arm

    No matter how hard I pushed on mine, they would not clip into place. I used a small flat head screwdriver and pressed the "clip" part into place and it worked like a charm. I can make a video if you need me to be clearer than that.
  11. Windcalmer

    Typhoon H rebuild

    That what I tried first was my entire set of snap ring pliers. None of them area small enough. Maybe I will go with blowing them out with compressed air first and then move on to more in depth cleaning if that doesn't work.
  12. Windcalmer

    Typhoon H rebuild

    Thank you for that software link. I just went through the last few logs and found that I need to replace two motors. That software is amazing! I am in the process of replacing the motors and then will be doing test flights once it is no longer raining here in Georgia. SO far it has been raining...
  13. 20191211_144929.jpg

    20191211_144929.jpg

  14. 20191211_145010.jpg

    20191211_145010.jpg

  15. Windcalmer

    CGO3+ needed

    I am looking for a working CGO3+. You can PM me or post here f you have one for sale. Mine died when I crashed and I am finally at the point of needing to get another. It is going on a Typhoon H so it has to be compatible. Thanks guys and girls!