Recent content by xxkachellxx

After many hours searching i got conclusion - pagoda on st10+ was bad idea, i downgraded that to stock st10+ 5ghz antena and is wayyyyyy better, and i ordered New helical for st10+ and lolipop for Q. I Will give info about results.

Hello Guys, I have problem with my Q, i can only fly around 200ft. (sometimes 50ft.) and i got massage, unable to connect camera, reconecting, it is randomly, sometimes video can reconnect without fly more close to me, sometimes i need to land and wait a minute to again connect. I have changed...

I bought them with shipping for about 70 USD, in my country Poland. As i checked banshing gens ace 8500mah should fit into bat bay.

Hi, i have got that redox 8000mah batt, i have done 2 flights, both about 20min flight Time, with gimbal and camera, strong wind and i didnt flew slow. I think 25/30min is possible with that batt, but with no wind and slow Flying. I can still use yuneec batts, but i preffer that option cause of...

Finally i have done that mount, and it is working well, no buzzing, fpv via USB c works, that simple conversion cost me about 10$, no needed 3d printer

I have made Just small conversion, i added xt 60 to battery bay and i can still use normal yuneec batteries and other aftermarket batteries. I dont have yet other bat, but i ordered redox 8000 which Will fit i to battery bay and as i think it should work, i Will give you info results when i Will...

I have idea, i made two of them one 3d printed and one from plastic that i bend, plastic is better than 3d printed and i think i have done mount holes for bearing and motor in bad places, So when i Will make New i Will try to balance it with camera before drilling mounting holes So it should work.

Xiaomi yi 2k which i have now weight 72 g the same as gopro 3, and i have that problem, and im waiting for my New xiaomi yi 4k plus that weight 102g. One more question, is that buzzing causing any problems? F.e. Burn motor or sth else?

Hello guys, if someone could help me, please do for me and as i think other guys make a 3d Cage for xiaomi yi 4k plus to print 3d, i do my own but it dont work well because gimbal is buzzing.

I want mąkę adapter like this but i need diamensions i want to make it before my gimbal arrive to me, i need Just mount holes for adapter and space between Motors and diamensions of sensor.

Ok nevermind i ordered Gb203 with mk58, could someone post diamensions of Mount for camera? I want to mąkę my own in 3d printer to have option to other cameras like xiaomi. I need mount/housing diamensions between Motors for UP and down moving, and Mount holes in that and the place of sensor on...

I though that start stop wouldnt work but its fine i have 64gb card So i can record a lot of flights even with turned on recording in camera.

I know that gopro 7 is bigger and xiaomi yi too, but as i said i can cut a Little of gimbal to fit (physical) camera into it, and i need to know it is possible to get video from camera from USB c to mk58. It should work i think, and is that gimbal support that moving UP and down from st10+? I...

Hello i want to buy Gb203 gimbal with mk58 transmiter to my q500+ drone instead of cgo2+ camera, and i know that gopro 3 and 4 are supported, but is it possible to make it work with gopro 7? I think i can cut something if it Will be needed, but what about live video in st10+? And do someone...