Gimbal Fault

[Adamday331]

Had this strange fault last night on my second flight after the new firmware. Flew along along the beach, the telemetry and video started to break up before 5000ft. The camera seemed to level itself out after a minute or so. But something went wrong for a short time. Also had a obstacle avoidance fault flash up on the screen even though it wasn't active.

 

[Goh]

Had this strange fault last night on my second flight after the new firmware. Flew along along the beach, the telemetry and video started to break up before 5000ft. The camera seemed to level itself out after a minute or so. But something went wrong for a short time. Also had a obstacle avoidance fault flash up on the screen even though it wasn't active.

Try to recalibrate the gambal

 

[Adamday331]

Try to recalibrate the gambal

I recalibrated everything after the new firmware. It was fine till that point and seemed ok afterwards. Not sure why it did it though

 

[OnTheRopes]

I had this same issue after the FW update, I had recalibrated the gimbal straight after updating. Anyway after a wonky cameraflight I re-calibrated again and all is well.

 

[Goh]

I recalibrated everything after the new firmware. It was fine till that point and seemed ok afterwards. Not sure why it did it though

Try to recalibrate one more time should be able to solve

 

[Adamday331]

I had this same issue after the FW update, I had recalibrated the gimbal straight after updating. Anyway ag=fter a wonky cameraflight I re-calibrated again and all is well.

I'll re calibrate it again then, cheers.

 

[OnTheRopes]

I'll re calibrate it again then, cheers.

Let us know if it works

 

[Adamday331]

Captured this shot later in the evening of the Spinnaker Tower. Straight off the camera, I was quite pleased!

 

[Dragonflyerthom]

Very nice pic. Post more please.