Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Team / Slave mode ...

Anyone an idea how to cancel the slave-mode ? Can not find how.
I could try a full reset, but do not think this is the best way.
 
Hello all,



How can I cancel this and make it a second master again ???

Anybody an idea ?

hi

how you did "bind" the slave ?
- activate slave mode
- yellow popup window "enable slave" checked true the rectangle
- "slave mode" named the window title
- press link push for scan "vehicle wifi cam"
- select the vehicle wifi cam example E90_989879
- write the password for the wifi link
- connecting - connected
- now your second ST16*** is slave

how canel this back?
you can't press the slave button again for unslave it
you must go back the steps simply
- unconnect the vehicle wifi cam by link press on right bottom corner
and use the "Reset All Links button"
now the slave button is normal colored again
- press slave mode and uncheck the enable slave mode

second way
if you switch on the slave only, ( no WiFi link-ed- ) the slave button is normaly colored and you can push it for disable on the yellow pop window "Enable Slave Mode" so long - so long the slave ST16*** did not connect to a WiFi -
if so - you have first disconnect the WiFi ( vehicle ) and i suggest you to "Reset all Links" by press the button there

you are done.

best wishes
rudi
 
I tried this, but when connecting it back to the same camera, it automatically reverted back to slave-mode ... Looks like it remembers it.
I would like to have two full controllers. Isn't that possible ?
 
Did you uncheck the Enable Slave Mode
and did then change the Window Title Color
you must then 'close' only the yellow popup window

watch the 4 picture i did attached
remote in slave mode, you have only 2 items over the vehicle point
after disable the slave mode
you get all items back from vehicle

note:
the (auto) binding process is done over the Wifi CAM
this trigger over the Wifi CAM the bind process.
if you not set the Wifi link passwort ( standard 1234567890 )
so you can bind with each remote by pressing 1234567890 as passwort on link
to the H520, suggest you, change the link passwort to your own.

it remember the link process, if you did onetime press the password for the wifi link
you allways can connect without extra steps - so be carefull with the password.

if you want "clear" the bind process, i suggest you to do 2 steps
- first in setup datapilot wifi link by "Reset All Links"
- second in android wifi network hold press on the link and select "forget network"
then you have a master back - and if you want use the remote as slave
you must bind over wifi passwort again ( i think this is the thing you searched )

hope this helps
best wishes
 

Attachments

  • Pic1_Slave_Mode_Remote.jpg
    Pic1_Slave_Mode_Remote.jpg
    59 KB · Views: 14
  • Pic2_Slave_Mode_Remote_disable_Slave_Mode.jpg
    Pic2_Slave_Mode_Remote_disable_Slave_Mode.jpg
    124.4 KB · Views: 15
  • Pic3_Slave_Mode_Remote_disable_Slave_Mode_Window_Title_Color_changed.jpg
    Pic3_Slave_Mode_Remote_disable_Slave_Mode_Window_Title_Color_changed.jpg
    145.3 KB · Views: 14
  • Pic4_Slave_Mode_Remote_vehicle_items_comes_back.jpg
    Pic4_Slave_Mode_Remote_vehicle_items_comes_back.jpg
    110 KB · Views: 14
  • Like
Reactions: arruntus

New Posts

Members online

Forum statistics

Threads
20,952
Messages
241,578
Members
27,284
Latest member
csandoval