Welcome to YuneecPilots.com!

Sign up and join the fastest growing Yuneec drone community.

Updating ST10

Discussion in 'Q500 4K Help' started by Juanvee6764, Jul 11, 2018 at 5:32 PM.

  1. Juanvee6764

    Joined:
    May 9, 2018
    Messages:
    31
    Likes Received:
    5
    Location:
    Durham, NC
    Ok so I have been trying to update the ST10 per Yuneec's instructions. So I downloaded the updated version, I did not unzip it, copied it to a blank sd card, put the card into the sd slot under the battery and turned the remote on. Went system settings, went to about flight mode control, went to radio control update and the file is not there for me to choose in order to update the controller.

    What did I miss?
     
  2. Steve Carr

    Steve Carr Moderator
    Staff Member

    Joined:
    Dec 15, 2015
    Messages:
    4,830
    Likes Received:
    1,779
    Location:
    Bessemer, MI
    Perhaps it's already up to date. What is the firmware version you see listed in About Controller?
     
  3. Juanvee6764

    Joined:
    May 9, 2018
    Messages:
    31
    Likes Received:
    5
    Location:
    Durham, NC
    I am seeing build number: st10+v01b29c and on Yuneec's page I'm seeing: ST10+ Build st10+v01b31c as the update.

    Model number: ST10+
    Android version: 4.0.3
    Kernel version: 3.0.8
    Build number: st10+v01b29c
    Hardware version: P1.4

    This is all under About Flight Mode Control
     
  4. Steve Carr

    Steve Carr Moderator
    Staff Member

    Joined:
    Dec 15, 2015
    Messages:
    4,830
    Likes Received:
    1,779
    Location:
    Bessemer, MI
    Your ST10 is up to date. The firmware number is different than the version number. If you look at the pdf file there is a picture of the final build number which matches yours.
     
  5. Juanvee6764

    Joined:
    May 9, 2018
    Messages:
    31
    Likes Received:
    5
    Location:
    Durham, NC
    Ok thanks, just saw that most of the numbers were different and thought that Yuneec finally came out with an update. I take it since it's been three years since their last update that they are not going to do anymore for this platform.