Yuneec breeze controller take off/land button reconfigured itself as a back button

[Cgansmann]

My breeze controller connected to phone fine and worked well but then one day when connected I couldn't take off, the start button/ take off/ land button acts as a back button and exits out of controller mode screen.

 

[DoomMeister]

There is a small hole on the under side of the controller marked ‘reset’. With the controller powered on, use a straightened paperclip to press the switch inside for a count of 30.

Then power off the controller. Then power on using Power + A if using an Android phone, or Power + Y if using an iOS phone.

This should restore proper function, if not call Yuneec Customer Support.

 

[DoomMeister]

Hey Cgansmann!

Any luck doing the reset on the controller?

Also, welcome to to our forum community. We have a lot of good people in our membership and tons of shared information at your disposal. The search function can find the information you need most of the time and when that doesn’t quite do the job, post your question and someone in the community is bound to know the answer.

We have a game going in the Photos and Videos section of the forum. It’s fun and open to all Yuneec aircraft. The rules are in the first post. Here’s the link The Yuneec Pilots Picture Game

 

[Scott_in_Colorado]

I’m also interested if the reset worked.