Recent content by hoggyjay

Been a while! I've tried to update the drone by coping the updated firmware to the SD card. I keep getting a message saying the SD card does not contain the update then get a network error message at the bottom of the screen or told the card isn't detected in the camera. I've cleared the flight...

Hi, I am struggling to tell if my controller needs a firmware update or not. The numbers on the screen don't seem to match anything on the website. I had to replace my controller and this would explain the difference in the aircraft numbers. I am in Europe. Cheers, Hoggy

Cheers.

After a crash I lost a gimbal rubber mount and a retain rod. I ordered the following kit - Yuneec Typhoon H CG03+ Camera / Gimbal Mount Set The contents only have two of the retaining rods. Do I need a rod in every rubber damper? If not where do I position them, my guess is opposite corners...

Hi All, I am about to use my wand for the first time with the intention of following a MX bike. The track is very tight and twisty so am not worried about the speed the H can fly at. My concern is the elevation drops and gains. Does anyone know where the H gets its altitude reference...

Time limit is set to 180mins. No idea how to change this?

What resistance should I be looking for?

Here is the problem - My charger gives an audible alarm and stops with this screen The CAPA I'm guessing is capacity? If I start the cycle again the battery reaches 16.77v and last along as the one in the standard charger. I can cycle between settings and can see the end voltage. What am...

I am the awkward guy with the Mac. Is there anyway in IOS to change the camera model?

The charger signallled that the battery charge was completed after approximately an hour. I don’t recal the voltage of the batter when it was placed on charge. I landed the drone minuets after the first low battery warning (new pilot, don’t want to push anything). I’ll pay more attention to...

Hi, Tried to use a Turnigy ACCUCELL 6 charger and a Yuneec balance lead for my Typhoon H battery. Everything seemed to go well, Amp set to 5.4, four cells selected for 14.8V. I can't honestly say if I selected balance or just charge. I did scroll through the menu during the charge and the...