Hi
I have a recurrent problem with my ST16+ controller.
I lost the connection to the CGO3+ 4K-resolution camera.
When I start the controller, each time, is asking me to select the richt camera type; the following message come:
"Camera connection status"
"Camera type is not match"!
"Please select right camera type"!
I brought the hole drone for repair to a local dealer one year ago here in Zürich (Migros), they brought it back to me saying:
"The drone have no problems" but the camera was binded to the controller!
Again I have the same issue and each time when I click on "OK" bring me the display to "camera type" where I cannot select the cam (connection error).
There is no way to use any other menu on the main menu, because each time when I exit the "camera type" menu it loops again to the
"Camera connection status" message.
There is NO way to enter Android to reset or clean the cache, no way.
Some tests I did:
The camara w-lan is seen using a phone.
Moving the drone to enter the "binding" process, only the drone is seen.
Update again same firmware, but continue with the same message.
Any good ideas to help me?
TIA
Jago
I have a recurrent problem with my ST16+ controller.
I lost the connection to the CGO3+ 4K-resolution camera.
When I start the controller, each time, is asking me to select the richt camera type; the following message come:
"Camera connection status"
"Camera type is not match"!
"Please select right camera type"!
I brought the hole drone for repair to a local dealer one year ago here in Zürich (Migros), they brought it back to me saying:
"The drone have no problems" but the camera was binded to the controller!
Again I have the same issue and each time when I click on "OK" bring me the display to "camera type" where I cannot select the cam (connection error).
There is no way to use any other menu on the main menu, because each time when I exit the "camera type" menu it loops again to the
"Camera connection status" message.
There is NO way to enter Android to reset or clean the cache, no way.
Some tests I did:
The camara w-lan is seen using a phone.
Moving the drone to enter the "binding" process, only the drone is seen.
Update again same firmware, but continue with the same message.
Any good ideas to help me?
TIA
Jago