- Joined
- Mar 25, 2018
- Messages
- 2
- Reaction score
- 1
- Age
- 67
Hi, Following a mishap, commonly known as a crash due to pilot error, I have replaced the landing gear actuator and motor arm retaining spring, and refitted two of the gimbal cushions but on setting the aircraft up to return to flight the camera will turn left, reaches a 'sticky' point where it turns very slowly, then continues. It will not turn right and having had the aircraft turned on for a while there was a significant level of heat coming from the housing above the actual camera. The cover over the PCB is also loose and the PCB is at an angle but looks sound.
i've seen the other thread about hard reset for a tilting camera which I shall try but if anybody has an idea about turning & heat issues I'd be grateful to hear them
Cheers
i've seen the other thread about hard reset for a tilting camera which I shall try but if anybody has an idea about turning & heat issues I'd be grateful to hear them
Cheers