I know this has no connection to the Typhoon H, but since it's the only drone forum I'm a member of, I thought I'd seek help here. I recently had a crash with a 350QX3 that rendered the stock body useless. I purchased a Microheli carbon body for it and did the installation. After installation I did a re-bind and went outside to arm and test for arming, run up, etc. All good "except" the motors will not run up. They arm ok but will not go above "idle" regardless of stick position. I get gps lock within 15-20 seconds, correct status light sequence etc., but the motors just will not spin up. No props installed at this point. Any suggestions?? Thanks in advance!