Here is the situation.
Was on 5th flight in front yard and all of a sudden no control. THPro lifts up and strafe right then comes down into my antenna.
I make repairs to a broken arm and a landing gear.
Everything fires up with the exception that I cannot start motors. I observe no telemetery data however I have video.
I try to re-bind but observe NO SSID from aircraft, however, I have SSID from camera.
I go inside and download ST16 FW, THPro FW 3.04 and 1.28 and GUI
I copy ST16 FW to SD Card and insert in ST16 and update.
I then fire up GUI on Windows10 and turn up aircraft and connect USB.
GUI detects aircraft and go to sensors screen and ALL GREEN.
I go to tools/firmware update and choose 1.28 to downgrade prior to uprading to 3.04.
When I initate firmware upgrade for 1.28 via GUI after proper detection of aircraft, I get erase fail then I try update again and get another erase fail and if I do it again I get com port 9 access denied.
I get the same results if try FW 3.04.
I cannot update via ST16 due to the fact that I cannot see a SSID from aircraft to bind to.
I've opened the aircraft and double checked ALL connections even reseating the connections for all GPS, dual antenna connections, camera connections, and realsense connections.
I place aircraft in bind mode and still no SSID appears in settings/bind in order to bind to aircraft. Yet, I can bind to camera with no problems.
I am at a total loss. I've tried different batteries, different USB cords. Nothing works.
Could really use some help. I've invested a **** of a lot of money in this to only have it sit on my desk.
Has anyone experienced this??
Was on 5th flight in front yard and all of a sudden no control. THPro lifts up and strafe right then comes down into my antenna.
I make repairs to a broken arm and a landing gear.
Everything fires up with the exception that I cannot start motors. I observe no telemetery data however I have video.
I try to re-bind but observe NO SSID from aircraft, however, I have SSID from camera.
I go inside and download ST16 FW, THPro FW 3.04 and 1.28 and GUI
I copy ST16 FW to SD Card and insert in ST16 and update.
I then fire up GUI on Windows10 and turn up aircraft and connect USB.
GUI detects aircraft and go to sensors screen and ALL GREEN.
I go to tools/firmware update and choose 1.28 to downgrade prior to uprading to 3.04.
When I initate firmware upgrade for 1.28 via GUI after proper detection of aircraft, I get erase fail then I try update again and get another erase fail and if I do it again I get com port 9 access denied.
I get the same results if try FW 3.04.
I cannot update via ST16 due to the fact that I cannot see a SSID from aircraft to bind to.
I've opened the aircraft and double checked ALL connections even reseating the connections for all GPS, dual antenna connections, camera connections, and realsense connections.
I place aircraft in bind mode and still no SSID appears in settings/bind in order to bind to aircraft. Yet, I can bind to camera with no problems.
I am at a total loss. I've tried different batteries, different USB cords. Nothing works.
Could really use some help. I've invested a **** of a lot of money in this to only have it sit on my desk.
Has anyone experienced this??