Hi
As I stated in my intro, have a "hand me down" Typhoon Q500 4k, CGO3 camera and ST10+ receiver.
I replaced the airframe and #2 motor and card. Downloaded the GUI on the computer and done the systems check to recognize the new motor and card. All good.
Problem......
Dont get any telemetry or functions on screen.
Power up the receiver, then drone as per instructions but receiver is not binding to drone. (I think) Binds to the camera, as in, I get picture on the screen but no other function. (cant tilt but will record)
I go through the binding process, turn on drone, tilt twice to get orange LED, turn on receiver, select "Model select" but that's as far as I get. I cannot select the current drone or new drone.
I have no other functions on the receiver, touch screen or any telemetry. Everything is zero.
I have read instructions, Googled and searched the forum but seem to be doing the same over and over.
My frustrations are ramping up my ADHD!
What am I doing wrong?
As I stated in my intro, have a "hand me down" Typhoon Q500 4k, CGO3 camera and ST10+ receiver.
I replaced the airframe and #2 motor and card. Downloaded the GUI on the computer and done the systems check to recognize the new motor and card. All good.
Problem......
Dont get any telemetry or functions on screen.
Power up the receiver, then drone as per instructions but receiver is not binding to drone. (I think) Binds to the camera, as in, I get picture on the screen but no other function. (cant tilt but will record)
I go through the binding process, turn on drone, tilt twice to get orange LED, turn on receiver, select "Model select" but that's as far as I get. I cannot select the current drone or new drone.
I have no other functions on the receiver, touch screen or any telemetry. Everything is zero.
I have read instructions, Googled and searched the forum but seem to be doing the same over and over.
My frustrations are ramping up my ADHD!
What am I doing wrong?