Recent content by 5ch4R

This is like an advanced version of parrot's disco

Canada for me.

Of course. Bought it new in 2016. Never had a single problem with it. Id rather it connect slow and be reliable, than connect fast and crap out on me.

Yeah ill start there. I have a DJI mavic and holy $h1T is it ever unreliable. Gimbal issues left right and centre. Gonna probably sell it and buy an Autel EVO or a Mantis Q, any experience with either of em good or bad?

Hello all. Havent flown my bird in awhile. But i got it up in the air and i noticed it was acting a little funny (not a dji style firmware crash) but i noticed it was swaying a little from side to side. Just wondering if yuneec released a new firmware update for the H480 or not as i know...

I personally check camera for hairline fractures, check to make sure it is calibrated properly, i use the same method on the upper and lower shell, then once the aircraft has been approved by me. I will idle the motors, checking for abnormal sounds and or wobbling (can indicate many things) i...

I use it when i land. If i go to land the drone and ill have it just barely above the ground probably a couple inches up, ill push the red button and itll slowly come down and ill get that nice easy landing every time. It entirely eliminates the risk of a flip.

I also apologize for the delay in getting back to the post. As i have been very busy these days

Its probably my resolution. Because i have a software called 5kplayer. It allows 4k videos to be played on my PC. My components aren't the problem. It is my monitors. I dont have access to a 4k monitor currently

What id do is id run it from 4k to 1080p edit it and go from there. I mostly just splice an audio file with it. I dont care for all these "glamorous" looking videos and photos. Each to their own though. I respect the work one goes into making that

Well i pirated sony vegas 13. Just learning how to use it currently. However my footage was very glitchy right on the ST16

I had that problem too when it came back from staples. However it was just simply stuck. I was able to get it unstuck by toggling the switch up and down until i noticed the gear retract. But that was just my isolated case

14.8V should be what they are rated at when they are half discharged. I believe anyway

So i should render it on my phone or pc then before i do anything else

My card is a U3-V30 card