Recent content by Andraika

oh, got my props yesterday. Rubik, thanks for showing the right way- channels was mixed wrong, no idea, how and why, but now it works like a charm :)

already did in channel settings, right joystick act as eleron and throttle at the same time, disabled red J3 button, now on the screen it acts as it should, but my H flipped over when landed so I'm waiting for new props to test...

thanks for fast response, I did as you said- went to channel settings- ele button, only J3 is red, final output monitor respond only to right stick control up/down on 80%. drone acts the same..

hey all, after a long pause I decided to lift my H again to the sky and got a weird problem- right joystick, when moving drone forward, is lifting it up and the same backwards- landing drone down when moving. Left joystick act as it should. Joystick mode is set on 2. Hardware monitor shows...

Steve, many thanks for the link, I'll try to repair it!

nevermind, I'm waiting for DJI spark arrive :) and motherboard for TH is relatively cheap, just about 125 usd. or maybe there are fuses or jumpers on it to solve the problem, I'll try to google it. **** happens from time to time.

Crap as well.. I dissconnected my cam just to measure voltage with voltage tester and unfortunately shorted circuit between pins on H, now my cam also hanging like a dead apple.. :( but I saw little spark! :)

well, yes, cam should light up :/ is it still without life signs even with connected cable?

you can connect your cam to pc direct with usb cable

maybe you need update your cam firmware.

is it possible to change (increase) flight speed also? I have only about 25 kmph in rabit/angle mode with obs. avoid off, seems a bit too slow :(

I got 24 minutes without maneuvering, just hanging above the ground in light wind untill emergency touchdown. Just for test purposes.

it is only me in whole Sweden??? sounds spooky..

the same happened to my as well..

confirmed, code LUCKY7 still works! ordered mine itelite maxx today :)