Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by Bartek

  1. Bartek

    Typhoon H plus no take off

    You're right - problem with FC is the least likely :) So GPS module (or this little pill battery on it and/or wiring) is the prime suspect.
  2. Bartek

    Failure to take-off

    Small hint from me: sometimes you need to improve solder joints of the steering stick. Yuneec had some problems with oxidizable solder joints (I hope yopu understand - English is not my native language :) ) - and in about 70% cases this operation helps. If not - you need to clean or replace...
  3. Bartek

    card problems

    I know the problem - it's file format. Your cards will be working without issues in FAT32. How to format bigger card to FAT32? Windows won't do it - but there's a lot of tools that are able to do so - I'm using Raspberry Pi Imager. They (Raspberry) have exactly the same issue - so that's why you...
  4. Bartek

    Typhoon H plus no take off

    I've had numerous cases with not arming Typhoon H. The most popular issue: broken GPS module. Sometimes you only have to replace this small pill battery on board, sometimes the whole unit and sometimes - what is the worst - there's a problem with communication between GPS and FC, and ou need to...
  5. Bartek

    sys_autoconfig

    If something's not working properly - i.e. in full range - calibration is always the first solution and works in 95% of cases :)
  6. Bartek

    Gimbal gone wild.

    You can always look for tutorials in WTFD project - please look at attached file. You'll find photo tutorials how to fix your gimball there :)
  7. Bartek

    Gimbal gone wild.

    There can be also two other issues: 1. Check if these thin coloured wires that come from connector to slipring are ok (insulation problems, abrasions etc.) - I've had numerous cameras with this problem in workshop, 2. It may be also roll encoder - but less likely, cause with it are often...
  8. Bartek

    help h520 camera E90

    I would bet on K fuse - I've seen it before numerous times. Yuneec's hot swap is not very hot actually - and very often camera stops to respond after it's moved (even a little) in the socket. Would you give an info what happened? I'm just curious :)
  9. Bartek

    Hello from Vegas

    I still have a lot of customers using Q500 for aerial photography and they are not interested in buying new equipment at the moment :) Welcome!
  10. Bartek

    new battery 8000mah

    These Gifi-accus are of quite-good quality. We're selling them to our customers in Poland or other EU countries - and I must say, that we've got much more complaints concerning original Yuneec accus. We're selling Q500, H520 and H520E versions and we're using them internally too. Maybe it will...