Recent content by BestMd

To format the larger SD cards, I can use dos or Powershell for that. I'll post how to do that tonight.

I'll leave the 32gb SD in the controller. I have several new 128gb SD's available. If the camera supports it, I'll FAT32 one and insert it in there for storage. Thoughts?

Update: With a full battery, I took the drone to the park last night to test. After turning it on, the controller did not recognize the drone or the camera again.......... After turning on and off everything several times. Tilting, rotating and everything else, the controller still did not...

@WTFDproject and @h-elsner, a miracle happened last night before shutting down to go to bed. I went through all the steps provided and still nothing made a difference. I attempted again to connect the computer to the drone via COM 3 (did show up on my laptop). Still did not connect. I...

With a battery fully charged, lights are normal per the cheat sheet guide. Pics below from trying to update through the connection USB/cable with the GUI. One small feat discovered but just looking, the camera is not working and the after I was able to bind only it to the controller. The...

I'll send pics of the GUI after I get home tonight. I do recall when I turned on the GUI Preview there was some info shown.

@WTFDproject I thought I loaded this last night. Pic of the red lights on the rear motors. They blink 4x fast. Then off, then repeat. Fronts always stay blue **I'll get the battery fully recharged tonight.

The light is orange inside the air vents (Step 27). I don't recall the rear lights being blue flashing (Step 26) Ran through Step 28 without issue. See the attached pic showing the motor lights. The red ones are the ones I mentioned blink 3x but the blue stay blue. The camera light does...

Additional pics

No wifi shown from the camera, no items to bind in the menu either. (see pic) The rear lights below the motor are 4-red lights then 1 blue. Initialization failed? Green light is flashing from the camera mount. Wifi initialized? The tail light flashes several white then 1 each...

I'll check to see if the camera ID shows up on my phone or computer later after I get home from work. Thanks for the help

Well, thanks to @WTFDproject, and a 32gig SD card, the controller works and is updated properly. But there is still no "receiver ID" for the binding of the model or camera. Ideas?

I did use your form to try the update first. There was another on the Yuneec parts and file depot online. Neither worked which is why I suspected the SD card after that. I'll use your updated "Update" tonight after the new card arrives. Thanks for your input WTFDproject!!

I tried to bind per the set up sheet provided. I had to stop at item #37 because there was no "receiver ID". Neither for the camera also I used 2 different instruction sheets to update the firmware to "st10plus_tx_b32". I can transfer all the files to the micro SD card, but the controller...

The camera is a CG03. I will go step by step with the binding. It was odd, everything connected well after the first 2 "turn on's" then the camera connection didn't happen. In my wisdom of resetting the controller, all the set up data is gone. So I'll need to update that to start over.