Recent content by CincinnatiDrones

Is this with the original TYH or TYH with Realsense? Never had that Problem, except with Realsense...Had to firmware upgrade, now no problems with it. As some say only use it in follow and watch me modes I can say this... I've used it while in flight and when I turn it off sometimes it fly's a...

They are both the same height. Just different light and rotation on the 90 deg. If I would do a vertical shot to compare your saying is the only way ? It shouldn't bend anything as it is a distortion Free lens.

Two photos to share. Both taken from approximately 200 ft. You'll notice the vertical picture of the field is square. This was taken with my original TH that I got when they first released. Everything looks good. These are taken from a -90 degree pitch, or looking straight down. Now with...

They can go well, but if you do it wrong you'll brick your H. Follow their instructions to the T and all should go well. I have the firmware version .B27 and it's working fine. B23 was the firmware to watch out for if you have Realsense.

Send it back. You need a new stick assembly. I have had the H since it came out and just now had to send it in. Sticks get wore out on any transmitter. That was a warranty fix....Same for if you received a bad stick from wherever you bought it from. It sucks I know but send it in, it will...

Yes, this is where it will wear the fastest. The heat energy from the motor is directly transfered from the shaft to the hub. I personally haven't bothered with balancing my props because it A. Flies wonderfully as is. B. Props only have a minor part in multirotor flight anymore, as long as...

Np. Let me know. I am new to the forum but have been with Yuneec as a dealer since the q500 was released. I've seen mostly everything so far. Ask me anything anytime.

Wouldn't be a bad idea. Go through the whole process again and this time make a new model. Worked great.

Have you tried the new model tech? Are you still having problems?

Did you delete the previous flight data after the firmware update? Do a clean update of the aircraft, delete flight data from Pad->settings->flight mode. Clear data, create a new model, rebind and you should be good. Keep all cell phones and even the st16 at least 15 feet from the H when...

Just an update on the compass issues. If rebinding doesn't fix the constant reminder to calibrate even after you calibrate check your firmware. If it's under b27 then you need to perform a firmware update. They have all of the tutorials on their site under support. Follow the directions...

To all who bought the H Pro package with Realsense, if you're having calibration problems (IE keeps asking you to land in angle mode and recalibrate, gps lost, etc ) even after you calibrate. Go to your settings and create a new model and rebind to the H and the CGO3. This should fix your...