Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by Davidg8862

  1. D

    Keep getting cant connect to camera after lift off?

    Filmed a hospital yesterday.. Glad I'm able to start off being able to see video to get camera angle then get message can't connect to camera after a few feet...When I bring it back I can re connect and stop record..The camera recorded all footage and looked perfect
  2. D

    Keep getting cant connect to camera after lift off?

    This is the chip I'm using. And I'm shooting in 1080 60
  3. D

    Keep getting cant connect to camera after lift off?

    I will try that...I formatted the SD card as previously advised ...Didnt help
  4. D

    Keep getting cant connect to camera after lift off?

    Yes I have full function of the drone and the camera is still recording..
  5. D

    Keep getting cant connect to camera after lift off?

    I'm shooting in 1080...I formatted the chips I used today and will try again later...The recording is fine I just have no control over the camera and can't see what I'm filming at a very short distance. Thank you so much for taking the time to respond to me
  6. D

    Keep getting cant connect to camera after lift off?

    Just came back to view my test flights and the camera kept recording even though I couldn't see what I was filming on SD10 ...The picture quality is beautiful the reason I stayed with this drone in the 1st place....Now if I could only figure out the problem ....
  7. D

    Keep getting cant connect to camera after lift off?

    Got shoot tomorrow and need this to work
  8. D

    Keep getting cant connect to camera after lift off?

    I have 2 of everything...tried every combination ..factory reset on both st10s...same results on both...cant imagine what could it be on both units
  9. D

    Keep getting cant connect to camera after lift off?

    Just took them both out 4 test...Same results plus I did different combos. Different camera with different controller same results on both
  10. D

    Keep getting cant connect to camera after lift off?

    Never did updates... Everything starts out fine then after just a few seconds of flight ...Can not connect to camera....Happens on both...i deleted all settings on both...re bound on both same thing ....Picture records goes up a bit then can not connect to camera...also when I check film it...
  11. D

    Keep getting cant connect to camera after lift off?

    2 completely different set ups
  12. D

    Keep getting cant connect to camera after lift off?

    Need help...I have 2 different Q500 copters and having same problem on both...Everything is binded and I see picture on ST10 controller.. recording starts ...As soon as copter goes up I loose camera signal and says can't connect to camera...Its still recording but I'm flying with no...