Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by DJTempezt

  1. DJTempezt

    Hello from Northern Nevada!

    My problem came after I unlocked a landing gear module (jammed) which is not related to my current problem. I went flying afterwards and the drone veered off left and into a fence. No major damage 'cept the blades. I had to replace four of 'em and I tried again in a clear area. After taking it...
  2. DJTempezt

    Hello from Northern Nevada!

    My name is Steve and I'm a total newb when it comes to UAVs and....flying. :) I've been learning a great deal from this forum and continue to learn more. Since late March, I've been the proud owner of a Yuneec Typhoon H Pro. So far, I've been hit with transmitter issues (solved), landing gear...
  3. DJTempezt

    Searching for a Typhoon H flight controller

    With ebay, you're in the right area. I have seen Flight Controller boards for sale on there. They've been pricey from what I've seen, however, you might find a deal.
  4. DJTempezt

    CG03+4k Camera no WiFi to ST16

    So, I'm replacing just the WiFi module? or the Main Board or the Flight Control module.... and I'm looking at doing this on the ST16...correct?
  5. DJTempezt

    CG03+4k Camera no WiFi to ST16

    I've been paying more attention when powering on the drone with the camera attached and here is what I've been noticing. The camera DOES blink between red/white for a short period when starting up with the drone and then proceeds to the flashing green/orange lights (depending on installed/no SD...
  6. DJTempezt

    CG03+4k Camera no WiFi to ST16

    Just to let you know, I currently have no Wifi on my controller and can't get into tab mode to turn it on..... I've enclosed some photos Here's what I get when the controller finishes booting up. When I hit Ok, I get the following screen From here, when I hit select I keep getting the message...
  7. DJTempezt

    CG03+4k Camera no WiFi to ST16

    I'm referencing a Typhoon H with CGO3+4k, and ST16. A couple of days ago I took everything out and did a test fly. Everything worked fine and then shut everything down. Left everything in the case in my car overnight and was there until I arrived at another location. I unpacked all and started...