Recent content by Eraser

I have disconnected the yaw motor and what shouĺd I say... works flawless! Fixed the yaw axis in place and finished. Thank you very much everyone!

Can you tell me a little bit more what you have done here exactly? Did you disconnect all of the axis? Is the controllerboard of the gimbal still used or completely elimanted and just forwarding the power from the Typhoon to the camera? How does the camera LED and indication behave? So, if this...

Another option for me would also be, if the yaw axis can be disabled. I don't need it for my hobby photos and I can turn the Typhoon itself to move the camera.

Hello I have checked the cable from the connector I -> Continuity on all 6 wires to the metal tabs on the outside are OK The other cables from the connectors D, E, J looks visually good. I wonder if this helps: https://yuneecpilots.com/threads/gimbal-gone-crazy.8188/post-174067 I fear, that...

Hi After disassembling the CGO completely and checking everything, I reassembled it and thought let's try it again. Here is what I have seen: -) The death spin of the yaw axis is still there -) The video feed of the camera is functioning without problems -) After letting some time pass, the...

So here are now my test results. I'm reffering to this picture -) Cable from Connector A (Pitch motor): 3x 13Ohm -) Cable from Connector B (Roll motor): 3x 13Ohm -) Cable from Connector C (Yaw motor): 3x 17Ohm -) Cable from Connector F (Yaw encoder): Continuity on all 3 wires OK -) Cable...

OK thanks. I have checked the hole, this is in the same orientation like on your photo. Tomorrow I will check again all cables, encoders and try to measure the resistance of the motors. Wolfgang

So, I have checked the 3 wires from the tilt encoder and you were right. One wire was broken in the middle, but the insulation was still on. I have soldered them together and now after a test, I get a death spin, but without any beeps this time. Is there a problem with the yaw encoder? The yaw...

I already have ordered a set with different sizes of screws. If no one of these fits, then I will gladly come back to your offer. Thanks

Hi HE, I'm in Amstetten, Lower Austria. And you?

Thank you very much, I will inform you about the results.

Thank you. I will take the two screws from the side as you suggested. I wanted to buy a screw set with different sizes, but normally you get 1.0, 1.2, 1.4mm and so on. So it looks like Yuneec uses here some "special" dimension screws. OK understood. I will check the wiring from the connector at...

Hi Yuneec Pilots, my name is Wolfgang, I'm from Austria and I just started to fly a Typhoon H. Unfortunately after some flights, the drone crashed and the cgo3+ got damaged. Í hope you guys can help me with that. The obvious damages on the CGO3+ were: -) A crack in the upper plastic part of...