h-elsner's latest activity
-
Well, I finally got aroung to changing out the SR24 in the ST16S controller that wasn't working properly; primarily the camera controls... -
h-elsner replied to the thread Typhoon H low battery warning.Sounds like one or more dead cell(s). If you have a charger that can measure internal resistance you will see it.
-
Totally agree with @Steve Carr
-
I'm certain it is a battery problem. When a Lipo battery is stored fully charged or at a very low charge, it undergoes chemical changes...
-
I bought the Chroma with Spectrum radio installed and bought the Yuneec receiver for it as well with the idea of buying a Yuneec...
-
h-elsner replied to the thread 350 QX onboard battery replacement.Chroma as fun machine the is better with Spektrum. I tried the 350QX with SR24 and ST10. This is good for angle mode but not as good as...
-
h-elsner replied to the thread Replacement for the Typhoon H GUI.And what is the use case for that?
-
h-elsner replied to the thread So far, success!.Looks good. Sensor status and EKF status as it should be. If you are wondering why the FixType is 3D position, but the message GPS not...
-
h-elsner replied to the thread 350 QX onboard battery replacement.Do you have it with ST10 or Spektrum RC? The Chroma is more agile if you want to fly in acro mode it is the better choice compared to 350QX.
-
Cool! The only thing I have done with it was to power cycle the two batteries I got with it to keep them functional. I did not buy it...
-
h-elsner replied to the thread So far, success!.If the STMicroelectronics Virtual COM Port appears then the HW side to the drone is OK. I do not understand why Windows is not recognize...
-
h-elsner replied to the thread Howdy! Just flew in....The UAV Pilot simulator is based on Reflex XTR flight simulator (a limited part of it). The FAQ says the following: Does REFLEX XTR²...
-
h-elsner replied to the thread So far, success!.In the second video the HW error sound disappeared. Looks as it is OK now. Only a missing compass calibration remains.
-
h-elsner replied to the thread So far, success!.Very good. Driver and data capable USB cable are in place. I see no reason now why it does not connect. You can try to force COM8 in...
-
h-elsner replied to the thread So far, success!.Do you get a "STMircroelectronics Virtual COM Port" in the device manager when you connect the USB cable? And if yes, to what port it...
-
