Recent content by impaulb

I have no GUI program or know where to obtain such.I was not aware the QX 350/2 was programmable. All calibrations on the QX including compass,pressure and accelerator cals are done by binding the drone to the TX with different stick positions while binding.No computer needed. Motor cal is done...

Where do you get th is program? I have no alarms on and the light glows green to indicate GPS lock. I can then arm the drone and the motors will start to run slowly as in idle.Just no throttle response to increase the motor speed.In the stability mode (blue light) same thing motors will start...

Thanks.I'm not familiar with GUI or what exactly it is. I did do the standard motor assignment calibration though.

I forgot to mention all 3 drones are a Blade 350 QX 2 not a QX3 model

I have two DX6i radios One drone on one radio and the other two drones on the second radio using 2 models. I did bind the good drone radio to the sick drone and had the same throttle issue.The props are not installed for safety while testing.Funny about two of the three drones having the same...

I have 3 Blade 350 QX 2 drones. Two of them will not spool up the motors with the transmitter stick in the Smart mode (green light) They are armed and at idle speed. I get a bit of response but not much in the stability (blue light) mode. The third one works perfectly.All radio set ups are the...