Recent content by JesseG

ok that makes a lot of sense now. before I had an issue (when I had to calibrate my controller the first time) I had some issue with binding. I've only successfully got my Typhoon H to go into binding mode once. so found some solution to copy my current model in model select and recalibrate it...

if it is the slider. is that going to be an easy fix?

ok great thanks!

the k1 and k2 now are constantly changing in the calibration test...… ok this kind of frightens me. the beeping and the change of numbers in the calibration test screen. was due to the low battery my controller has. jandjfrench thanks for explaining in simpler terms for me. haha when I am in the...

ok thanks. what about to find error messages. is there a program I have dowlaod to my PC to see the messages because isn't a hook up to a pc?

but the last point. in any positions of tilt and pan switches. which they both are in the middle position. the gimball does not bring the camera to horizon shot like in picture 2 that I had sent. it does not get to that angle.

beeping is from the ST-16

just calibrated gimball and still is making constant beeping while camera I going up and down.

wish I could brush up on the basics of diagnostics of the drone. the piece went missing a while bkkac. could you provide a link and a website or a store that could provide the part?

before the incident. I didn't have to have the tilt and pan in upward. it had the horizon shot with both switches in the mid point. I believe since I had no idea about what they did. now calibrated correctly I can obtain the horizon shot with just pushing the wheel to the max (where it beeps)...

this angle is after ive been in flight and look down. trying to look back up.. this is where the camera stops.

this is the normal angle in which the camera is set.

I've tried everything and this is the end result. I will upload pictures to give a better understanding of the issue.

It seemed fine. there is a shot time which it works. like when it starts up the camera will look forward but when I aim the camera down and when I try to angle the camera back up it will not turn straight forward so it will fall a bit short of the correct position it should take. the 431-800 is...

so I'm still pretty new to flying but I had one of my propellers broke. my drone fell into some water. I let everything dry for a long time and then decided to see if all works. by a miracle it did. after a minute an error read " error. entering five rotor mode". which confusing since its a...