Recent content by JMichael

Just curious. Has any one heard any reports of RID information gathered near any one of these sightings? Civilians should be able to download Drone Scanner and get some type of info. Granted not all uav operators are playing by the rules...I get that but there should be at least some info on...

Thank you for the help and the guidance! May every hawk in the land ignore your drone! :)

Thank you for the response. Regarding the contact pad, yes, the connections at the top of the gimbal. Someone else changed it but the original is not damaged. Do not know why it has been changed. Only included that info to help the elimination process. Regarding the beeps, there is a sequence...

Hello! After a small crash with a Typhoon H+ C23 beeps and will not initialize. The roll arm was tweaked and is now straight. I cannot see any damage to the flex cable. Camera does not produce any video. Camera light does not illuminate. No pitch control Pitch magnet is good. C23 contact pad...

Thank you for the reply. My magnet has turned to dust. CGO 3 lives in Florida most it's life. I have replaced these magnets in the past and I have found a way to get around the calibration process. It does take time but the end result is achieved weeks sooner than sending it in.

Hello All! I am reaching out in the hopes that someone here may have a CGO 3 Pitch Magnet for sale. I have replaced one in the past and I am aware that this magnet has to be indexed for the system to read it correctly. If anyone reading this has a Pitch Magnet or a used (budget) CGO 3 with a...

UPDATE: SUCCESS!!!! With the help of very talented and generous individuals, I have brought this cgo 3+ back to life! I cannot thank this community enough. After narrowing down the cause of the issue, I was able to focus on the solution. In this case, the solution was a replacement of the...

I have performed the the encoder swap. ] The gymbal acted exactly the same. I have observed that I am getting the the encoder beeps (Long Long-short short). I grabbed my multimeter and set it to 2000k ohms. Not looking for a specific value, I tested the A5600 pitch motor chip, then checked...

I will get on it tomorrow. Will post update soon. Thank you again for your help!

We have continuity.

Thank you for the advice.

Yes sir.

Awesome! Thank you for the info. Just downloaded it. Here are some images of the roll magnet after cleaning. A small screwdriver will stick to it. img 0972, you can see brown discoloring at the left solder pad of the encoder. Do not know if that is normal, just noticed it and thought that it...

Finished with the inspection and found no bare wires of faulty connections. I did find that the roll magnet was covered with iron ore and the surrounding frame was covered with sand. Also found iron ore very close to the roll motor, covering the copper wires that extend out from the resistor...

Thank you for the quick reply. Will start checking for a dead short now. Will touch base soon with an update. Thank You!