Recent content by jnmchlmnnn

I tested the led directly at the led contacts. And only Red and Blue from the RGB are lighting up. No Green. So that explains my confusing light signals. I will order and replace the main LED unit. Thanks for the help!

I checked the little board which has the led and that looks all fine. The wires disappear in the battery compartment. Where do they go/connect? How do I get to the other end to check connections?

Did this and found out that the Green is not working. Any suggestions how to restore?

After changing antenna on the st16 I managed to bind :-)) But my main led changes from solid purple to alternating blinking red and purple and drone beeps twice when changing to this status. Can't find the meaning of this.

It is absolutely red and very fast blinking

My copter does not go into bind mode. Following the binding verification pdf I get stuck on step 38. The rear led keeps blinking blue fast. And after tilting a while it changes to very fast red blinking. What can I do?

Purple blinking. Yes, telemetry is in the screen

Thank you. Going to check these things.

Yes. Binding is ok

Hi, I just got a used H wich is new to me. When I start up the copter I can see the camera gimbel positioning the camera. So the tilt and pan motors work. And the connection with the SR16 seems ok. I have image in the screen. But I have no control from the SR16. No tilt and pan response in any...