Recent content by KD0SYR

The servo came today! It is an nearly direct swap. The gear pulls off the defective motor on presses right on the new. The only issue is the plug is not the same. I opened the bottom covers and de-soldered and swapped cable.

I did some more testing. The gears are in good shape but the servo motor shaft was not rotating. The motor would cycle on for 3 seconds and off for 13 seconds without input from the controller. I was able to finally find a replacement camera assembly (camera, gimble and servo) for $79.99. I...

I inherited a Mantis Q. I have one issue remaining. The camera functions but the gimbal works very intermently. I removed the top cover and removed and reconnected the circuit board on the top cover. With the drone powered up and the remote connected the gimbal servo motor will run for 2...