Correct - thank you sir. The only items available are what's pictured. There is not a drone (typhoon h) available. It was having a compass issue and it was destroyed in a crash. The camera was not attached at the time.
I posted this last year and there were several responses/questions. I was not getting notifications via email (for some reason) so I thought there was no activity. Had a really busy year and did not check the forum...I apologize to everyone for not responding. The items below are still available...
Steve I did. It’s in a tree about .3 miles away from my take off point. It has given me so much trouble over the last year....I didn’t worry with it. Would like to have the battery tho.
I purchased an Inspire 2 early last year. DJI for me from now on. I owned a q500..was a solid platform imo...
Long story short....after a year of trying to fix a GPS problem...my Typhoon H "flew away" today. So I am selling the back pack case, CG03+, St16, wizard, charger, all cables, straps, etc. I also have a set of lens filters (3).
$319
Thanks.
It's blinking purple. I have flown from this location many times. I may have a GPS module issue (I have a q500 that acquires in less than 3 minutes from the same location). But everything I've seen indicates that if I switch GPS to off...the motors should start.
Thanks.
Hi everyone.
I am having an issue with my H acquiring GPS lock. Obviously the motors will not start while "acquiring". I was thinking they would start with GPS switched off. However mine will not....should they?
Thanks!
Good morning.
While dismounting my CG03+ from my Typhoon...I dropped the camera. It broke one of the mounting pieces. To re-attach...one has to disconnect writing from a small circuit board. During this process 3 wires pulled loose before I could snap a picture.
I have searched high and low...
Thanks for the feedback!
I shot in natural/sunshine and white balance locked/manual over the grass (first shot - fairway). Later in the morning it became less cloudy and I didn't reset. A fair amount of colorizing in post production to green things up a bit.