Recent content by Lakeview173

Hi mine does the amber for a few secs. then solid red 3-4 secs. then flashing green. That's it, it doesn't relax and reboot. I let it sit for 1/2 hour the other day flashing green, camera still stable and no reboot. those 2 files were the only 2 files on the sd card. Thanks Andrew

No, no other c23 camera. the sd card with autopilot.yuneec on it file came out of the camera, after the update, changed to autopilot.yuneec.updated. would it make sense to get another main board? I saw one on ebay for about $100 from a new h plus?

Well I tried the 784 like you said. Still no go. the cameras light was solid red for a few, then flashing green. still had to pull the battery. thanks for the help

I’ll try that thanks.

I’m starting to think so.

Thanks Steve. I did as you suggested last night. I connected to qgc 4 or 5 times it connected every time, then close qgc and start again. after this it sat all night no battery, still no go. I would love to know a better way to install the autopilot. I think I have followed the procedure, but I...

Thanks for reply, I have done that several times now, still no boot up. thanks

yes I have thanks

Ok I hooked it up 4 or 5 times. I’ll do it again and close qgc first.

I think I just looked at the status screen. It said 2 items needed attention battery(not installed) and sensors, but I didn't touch anything else or try to adjust anything. The drone did connect and even loaded a gps map of where it was.

Thanks. Yes it sat last night with no battery. I tried the qgc connect but I would put a battery in and try it. I will try this other way now. When you disconnect from qgc, do you just close the program or just pull the cord I haven’t seen a disconnect on the qgc. Thanks again.

Hi, I tried the firmware again, let it sit for half hour. Nothing. Also after formatting the disc. I only put the autopilot.yuneec file again nothing

Hi ill try this. yes somehow QGC did something. I was just looking around, didn't tell QGC to do anything. thanks for reply

I let it sit for a little while, but ill do it again. the camera did stabilize, flashing red a couple min. then green flashing. I will let it sit for awhile. Thank you

Hi, I am new here, and with a new H plus with one flight on it, I was reading on the forum about Qground control to get log files etc. I plugged the H plus into the computer with USB. No battery installed and it connected fine so I messed with Qground a bit, unhooked everything, The next day I...