It may wind up there, but it would be great if we could find the issue with yours.
I am curious about exactly what sequence of lights and flop-overs you are seeing.
With ONLY "autopilot.yuneec" and "versioninfo.json" on the SD card:
The camera should start normally. (A few seconds of amber, a few more seconds of red, then the gimbal should stabilize, and LED should begin flashing green.)
About 1 minute, 12 seconds later, the camera should "relax". (flop over.)
About 10 seconds after that, the drone should reboot, then the camera should stabilize again, still flashing green. And that's about it.
There should not be ANY red on the camera other than the first red when the camera is powered up.
Does this should like what you are seeing?