Recent content by lenmoni123

What does "Magnet" refer to, in this case?

It didn't make any difference. About a minute after I powered up the drone and connected it to the controller, the camera suddenly rotated on multiple axes and tried to continue rotating. It eventually reached a point where it couldn't rotate anymore; in this position, the entire gimbal began...

The camera rotates downward, but it continues to drift upwards from the new position.

It continues to do this, even with the newly arrived YUNCGO3104 pigtail. How do I fix the IMU calibration? Should I try the steps at Horizon problem?

I just tested the setup with the PWM disconnected. I've noticed that, immediately after receiving power and rotating into a "stabilized" configuration, the camera tilts upward very slowly without stopping. Is this due to the disconnected PWM?

Now I understand. Thank you!

Then, the tilting issue is likely due to the drone and not the camera?

Will everything work correctly if I leave everything intact, tie-wrap the pigtail connector's PWM side to another wire (keeping it unplugged but out of the way), and only plug in the power side into the CG03? I ask this because Yuncgo3104 for sale | eBay only has one connector (opposite the side...

How do I disassemble the CG03 as to expose the board? Is there a guide on how to do this on this forum? I just want to confirm: the 'power side connector' has two pins and is plugged into L in the CG02+ while the PWM has three pins and is plugged into D in the CG02+?

How could I proceed without desoldering or splicing wires? I plan to throw away the CG02+ or sell it for parts.

This is great, thanks.

The Pig Tail cable from the CG02+ is still intact. Would this cable also serve the purpose?

I have a Q500+ drone. After its CG02+ camera broke in a crash, I searched online for a replacement and eventually purchased a CG03 instead (due to its higher video resolution). However, upon receiving the new camera, I immediately noticed that the wire the CG02+ gimbal uses to connect to the...