Recent content by Magilla

The ST10+ screen doesnt work properly anymore. So Ill be in the market for a replacement. Question; Is there a better controller which can be used with the Typhoon Q500 4k or should I stick to the ST10+?

Hi all. Well I've dismantled the controller to check for any anomalies and reassembled. No luck. Screen still not working. Is there a reset that can be done on the controller?

Hi Johnno Sounds good. I've just pulled the controller apart to check for dirt, corrosion and any loose stuff that might stand out. Going to give it a clean and see what happens. Just going to exhaust all avenues first. If that doesn't work, I will be in the market for a controller. Thanks

That's what I'm thinking. No part of the screen reacts except for the last 10mm square of the bottom right corner. (the last half of the "Model Select" button.) The only other part is the bottom panel return symbol and the + which brings up the volume slider but I cannot move the slide (if that...

From step 24 to 30 check out and are per the instructions. That's as far as it goes. 31. Press the “Flight Settings” button. ................press the button but nothing happens. The only part of the screen which works is the "Model select" button, the "return" button and the "+" (volume up?)...

Binding Sequence: 1. Turn on ST10+. 2. Allow time for the ST10+ to fully initialize. 3. Verify RED power indicator above ST10+ power switch is illuminated. 4. Verify the blue WIFI indicator is flashing. (directly above the on/off switch) 5. Press “Model Select” on the lower right of the...

Hi As I stated in my intro, have a "hand me down" Typhoon Q500 4k, CGO3 camera and ST10+ receiver. I replaced the airframe and #2 motor and card. Downloaded the GUI on the computer and done the systems check to recognize the new motor and card. All good. Problem...... Dont get any telemetry or...

G'day all Not my first foray into drones but have basically played with toy drones and mini's. Have just acquired a "hand me down" Yuneec Typhoon Q500. Damaged. Just replaced the airframe, props, #2 motor and card. Waiting on new batteries. I have managed to fire it up and do a systems check and...