Recent content by martofer

Yes, I agree, but it looks ok, I don't know what or how to find the problem in the main board?

So, unfortunately, I can't download any of those drivers on my PC, may be because I do it wrong, or my PC does not accept them . But may be that's not the reason I can't connect to the com port. So, I removed also all the peripheral and still doesn't connect at all. Should I remove the 4...

Ok, I guess then that I have to take the Q500 apart, that will take me some time to go over also all the points mentioned. So, I will be back here in a while. Thanks anyway for your very appreciated help.

So, this note some times comes up.

Yes , com1 Port is FTDI,, so, when I connect the USB cable comes the com1 port, if I disconnect it it leaves, but it makes no difference if I leave it connect it to the PC, and disconnect it from the Q500, or if I torn on or off the Q500, the com1 still the same. And the com1 does not accept...

So, the battery is not pressing down, the blue lights yes they are inside the red lights. So with and from where I can get that driver for FTDI.

Still no difference if I disconnect from the quad.

I'm tying on a different PC and the device manager assigned a Com1 only but still disconnected trying port com1

Switching on the drone, lights red solid the back and the two wings and white the front wings.

Q500 has a solid red light, no beeps or sound, does not bind to s10, when connect to PC via USB cable provided to Q500 does not connect to COM port for update firmware. Downloaded firmware and GUI for Q500 from yuneecskins.com.