Recent content by ml4088r

Power off, i can move it around and yes I can tease it to sit straight and level

I can't say as this is all new to me. The gimbal has alway looked straight down since I first powered it up. . I have also seen problems with both of my typhoon H not getting GPS locks.

TYPHOON H USER MANUAL Vcho3-2.pdf document I read the section on gimbal calibrations page 45

passed all tests. I guess its just something I need to get use to . I appreciate the help

Thank you I will look at that link now.

Both the hardware as well as in screen that comes up under volts ch 7 is smooth. If I move the tilt mode switch all the way down I get almost full movement out of the tilt of the camera

these are used units that I aquired

If I run it all the way up( away from me ) it barely make it point just below the horizon. In middle its pointing directly down. From middle to all the way down it really doesn't do much.

Thats what I'm going to try and setup . one for Drone 1 and the other for Drone 2

Im new to these drones. I'm trying to get two of these back to running order . This is a question about the gimbal calibration. I followed the instruction on setting the switches and trim on the ST16. The H is sitting on a flat level table. The reason for this is the camera points straight down...

This is the first time working with these. They were given to me. one of the controllers has 2 antennas while the other has three antennas. The information stickers on both are identical model ST16 , 2016AJ1824, 1154B-ST16. There are a few broken switches that I need to get replacements on...