Recent content by mmr

HI! I am so upset. My Typhoon H plus went to RTH because the battery was under 25 % . I couldn't make any adjustments to the landing pattern but the drone landed on a high tree. It´s there still. I couldn't even lift it or fine control it when it decided to come down. Gosh golly puppy doo doo I...

Yuneec Typhoon H and H plus have been most frustrating copters with SD-probs. I got a new C23 camera last autumn as warranty. Yuneec also added a card from Panasonic 16Gb, HC I U3 / 10. It works, but I have a feeling that this H plus should have at least V30 or at least writing speed of...

I flew it normally about twice before and now suddenly later at same days evening these started. Can it be FLY ZONE issue as I read somewhere else that Typhoon H plus uses openAIP map for zoning?

Does this have a connection to that I cannot fly with GPS in red area... Only in manual mode with my Typhoon H+. In my backyard I have normally flown lawfully, but now my new Typhoon H plus do not start engines at all if GPS?

Thanks I did that. Nothing new and helpful. Does a message from a log tell you anything NOT ARMING: Switch to a pilot flight mode first + the time of this happening

Ok here´s a pic from my ST16s. I binded drone and camera again. Calibrated compass. ( Earlier I checked updates and got message no update needed) Drone won´t start engines from control unit red button. Only if I change to "MANUAL MODE" it starts and flies without GPS. When trying to start...

In my opinion there was nothing wrong with cruise control. I must check that Steady drive and where to get it. Thanks.

That´s very weird as buttons and all would be same? Well noticed also that my H plus only take´s of in manual mode. Otherwise beeps twice and rotors will not start.

Does the cruise exist now? I am disappointed as CRUISE CONTROL was one of the best features in TYPHOON H.

Hi! I just got my Typhoon H plus, but I do not know how to set cruise control like I use to do in normal Typhoon H. Also I can´t find control unit ST16s calibration. Is there any? Only monitoring. And what is the right way to change dampers of gimbal. All 4 sticky gel or something.

Yeah, thanks! I got it now working :)

I have a new ST-16 but it doesn´t kalibrate sticks right. J3 always red and I took photo for you what happens when movin left stick (turn copter) to left or right. When doing it you can see from the pic that also forward and backward are moving. So when I turn my copter it activates also moving...