Recent content by pat4si

Hello, J live in EU, Can change m'y typhon Gps by Galileo ?? Pat

OK, this last picture is very well, the last image is the correct one, the connection between the resistor and the cpu is broken, dry solder on the resistor and cpu side and its OK, thank you very much for this help. Patrick sud of France ( Perpignan ) thank all community

yes j bound the mother board with a new receveir on this, !!! j create new model also !!

He Hello, to day j try the another motherboard to aircraft and its same problem, So I think that the camera fault. I check tomorrow if there is indeed a signal on tx / pwm (green white wires) with an oscilloscope. have you a electronic scheme to this part of camera ?? Patrick

Hello, yes corrects channels move on ch7 and ch8 Patrick

Hello, j do this and no change !!! Patrick

Hello, yes all is working Patrick

Hello, yes is this j checked wires of contacs aircraf to control gimbal board inside the camera on last connector , wires green and white. Patrick

When your camera starts, does it point forward and hold itself level? In post #7 you mentioned "I do not include the FC because tried with another". Do you have a second Typhoon H and CGo3+ camera available? If so, does the camera show the same problem when mounted on the other Typhoon H...

OK, well contacts from the camera connector to the camera connector where pwm is located everything is ok, not cutoff, so it comes from the camera motherboard, or drone motherboard side, I do not include the FC because tried with another. I specify that the camera works in video, stabilizes, but...

Hello, yes j use cg03 + Patrick

thank you for this return, but j verified all this , and its ok but gimbal does not work, !!!! somes time its make this default and it was enough for me to start the drone to solve the problem sometimes several times There is no sequence of initializing the camera at start drone, no more when I...

I have a Yunec Typhoon H Pro with Realsense and CG03 Pro, the camera does not work in Pan / Tilt and 360, but it stabilizes, no deffault and video beeps, I verified the binding tablecloth with the motherboard of the mother's drone and c; is ok, do you have an idea diagnostic ???? Thank you in...

j not know what connect to spkt/dsm pixhawk, the white grey black yellow leads or pcb connector ??