Recent content by Peavyxs

Yes to all of your questions, when put in storage they were properly discharged and fully charged before using. It only does it when the bird is lifting. I was looking at the esc’s and thinking about cleaning up some of the soldering I had done in a hurry to see if that would fix the problem...

I have tried several batteries, it does it to all of them.

Got another problem. Whenever I get lift, it completely drains my batter down to 10v if I let off from rising it will equal back to 11v but the battery won’t fully recover. This was happening after my last airframe replacement and was my reason for changing out the main board! So I’m guessing...

Did just that today! Connected right up. Reassigned esc’s and I’m good to go. Thanks for the help!

Yep I have it all hooked up right. Even connected the gps, when I did I got 4 different tones of beeps this time. Still flashing red. Gonna try to reinstall the GUI and drivers and see if that gets me anywhere

Q500 4K. The original issue was Just a burnt out esc, replaced it. cut it all on and the board went up with a puff of smoke two pieces on the back and one on the front are clearly burnt. Replacement was bought from a reputable vendor and had been tested and worked. Yes I’ve used the GUI...

Help. Replaced main board and rear esc Status light flashes red and has high medium and two low beeps.try to connect the GUI and all it will say is Disconnected Trying port Com3.

Well my first flight it worked great cut everything off for a few minutes, went back out and it started doing the same thing. I’m going to go back into the controller and try to tape down the connection on the board. I’m assuming it’s coming loose but it didn’t seem like that when I put it back on

I decided to go ahead and take the controller apart all I did was unplug the WiFi antenna from the board and plug it back in and I now have great video. Still plan to upgrade to something stronger but atleast I can fly for now.

Video on playback is wonderful as it’s stored on the sd card in the camera. It doesn’t matter if I have my phone connected or not it still lags that much

I’m having real bad pixelated and choppy video on my st10. I downloaded the cgo app and compared my phone to the controller. Controller video is always choppy and breaks up in green blocks and has a close to 10 to 15 second delay no matter how close I am to the my q500 4K. Video thru my...

Quick question after changing my airframe out I noticed that the antenna that is normally run in the legs is run in the wing instead, I bought this off eBay as refurbished so I guess what I’m asking is if having it run in the wing will effect the drones performance?